JC-SWA07-08 rotary push button switch with 6 terminals

Series:JC-SWA07-08 series

Description:

Type:                             JC-SWA07-08
Construction category:    D
Operation method:          Push button switch
Configuration:                 Single-Pole Single -Throw (SPST)
Terminal form:                Solder Terminal
Protection:                     IP40

Contact Now

  • Applications
  • Technical parameters
  • Remarks

Widely used in home appliance, electronic equipment, automatic machine, communication equipment, car electron, apparatus and instrument, electric motion tool etc.
Rice cooker
Slow cooker
Electric Heating Faucet
Shredder
Computer mouse
Electromagnetic lock
Baby chair
CNC machine tools
Power generator
Test equipment
Elevator
Power tools
Air conditioner
Water heater control panel
Bathroom products
Vacuum cleaner
Kitchen products
Gas valve
Range hood machine
Microwave oven
Pass-through machine


3.DETAIL SPECIFICATIONS:
Type:JC-SWA07-08
Construction category:D
Operation method:Push button switch
Configuration:Single-Pole Single -Throw (SPST)
Terminal form:Solder Terminal
Protection:IP40
Ratings 0.1A  12VDC
3.1  General
3.1.1Application This specification is applied to KAN-J4 Power Switch used for electronic equipment.
3.1.2 Operating temperature range -10℃ to +60℃                                
3.1.3  Test conditions Unless otherwise specified. The atmospheric conditions for making measurements and tests are as follows
Ambient temperature:15~35℃
Relative humidity:45~85%
Air pressure:86~106kPa (860~1060 mbar)
Should any doubt arise in judgment. tests shall be conducted at the following conditions.
Ambient temperature:20±2℃
Relative humidity:60~70%
Air pressure:86~106kPa (860~1060 mbar)
3.2Appearance construction and dimensions
3.2.1 Appearance Switch shall have good finishing, and no rust crack or plating failures.
3.2.2Construction and dimensions Refer to individual product drawing.

3.3. Electrical Characteristics

NO.

Items

Test conditions

3.3.1

Contact resistance

The contact resistance should be 50mΩ(Max).

3.3.2

Insulation resistance

It is measured with 500V DC 1minute should be 100MΩ(Min).

3.3.3

Dielectric strength

AC 1000V,1min.(before endurance test)

 AC 2000V,1min.(after endurance test)

 

3.4 Mechanical Characteristics

Item

Description

Test Conditions

1

Operating Force

500gf±50

2

Operating Life

The mechanical life all of 50 000 cycles

3

Contact Spacing

Min. 3.0mm (IEC61058)

 

3.5Durability

NO.

Item

Test condition

Criteria

3.5.1

Operation life



Measurement shall be made following the test set forth below:

DC 12V, 50 mA resistance load; Rate of operation: 60 times/min.; Operating Force1.5OF; Average fault-free life50,000 cycles


Test voltages shall be applied for 1 min

Contact resistance:

≤200mΩ

 Contact bounce:  

≤10ms

Operating Force:

initial value±30%


 

4. DRAWING & DIMENSION



PARTS LIST:

NO.

quantity

Items

Material

1

1

Core pin

PA66

2

1

Sheet

Phosphor bronze silver plated

3

1

Cover

Phosphor bronze

4 1

Base

LCP

5 1

Contact

Stainless steel silver plated

6 1

Spring

Stainless steel

Note: Returned plastic should not exceed 20%.

return